Wire Wraped Crystal Point Beads

Take one 16cm section of 22ga wire and measure a 1.5cm tail and bend it at a 90 degree angle (A). 

Thread the hole on the top of the crystal point wire on the longer section of wire so it sits next to the bend. 

Take the longer section of wire and bend at a 90 degree angle on the other side of the crystal (B). 

Now take both ends of wire and cross them over at the top of the crystal point (C). 

Take the shorter section of wire and wrap around the longer section of wire a few times. If needed trim and finished flushed (D). 

Create a wrapped loop with the wire (E). Take the longer section of wire down (F) and start wrapping tightly around the top of the crystal until there is only 2cm of wire left (G). 

Take the tail and upwards finish by wrapping around the wrapped section at the top. Secure and finish the wire flushed (H).